« Last post by sgould on 22 April 2024, 01:31:30 PM »
The problem you will have is that the exposed paint will be dirty. Unless you get it really clean, the lacquer won't stick. And, it's clear that the exposed paint is not suitable for getting lacquer to stick, as it hasn't stuck before. So you will probably need to sand down to get a key, which will expose the metallic particles and alter the finish.
Maybe a good clean and de-grease and a coat of lacquer is all you can achieve, in situ. But expect to have to do it again in a year.
« Last post by Steve McF on 22 April 2024, 12:40:49 PM »
My son is not too bothered that it doesn't have lacquer in places, but I'd just like to tidy it up a bit if I can. Worst case, i could probably find another bumper of the right colour from a scrappies, but I wanted to have a go on this bumper first, at least. If the colour is slightly off, he won't be too bothered, as it is already slightly off with no lacquer
« Last post by carrera on 21 April 2024, 09:42:01 PM »
There's what looks ike a decent diagnostic in WIS, but it does assume you have access to the tank
Buried away I see that for EU empty is supposed to be 250 ohms, full 40
You could try applying 12v in the appropriate places to measure the voltage the ECU would see - seems to be operating on 5v due to a 487 ohm resistor though. An idea anyway
« Last post by sgould on 21 April 2024, 07:27:16 PM »
It's sunny now, but too late to start anything. I may have a bit of time tomorrow, but she needs the car at some point.
One point I realised was that the CarScanner report said that the level sensor failure was "high output", which implies that there is less resistance than expected. So the sensor must reduce the current as the level drops. But it also implies that the sensor has a short circuit, not a break as I had imagined.